What is a Quantum Computer?
What is a Quantum Computer?
Behold your computer. Your computer represents the culmination of years of technological advancements beginning with the early ideas of Charles Babbage (1791-1871) and eventual creation of the first computer by German engineer Konrad Zuse in 1941. Surprisingly however, the high speed modern computer sitting in front of you is fundamentally no different from its gargantuan 30 ton ancestors, which were equipped with some 18000 vacuum tubes and 500 miles of wiring! Although computers have become more compact and considerably faster in performing their task, the task remains the same: to manipulate and interpret an encoding of binary bits into a useful computational result. A bit is a fundamental unit of information, classically represented as a 0 or 1 in your digital computer. Each classical bit is physically realized through a macroscopic physical system, such as the magnetization on a hard disk or the charge on a capacitor. A document, for example, comprised of n-characters stored on the hard drive of a typical computer is accordingly described by a string of 8n zeros and ones. Herein lies a key difference between your classical computer and a quantum computer. Where a classical computer obeys the well understood laws of classical physics, a quantum computer is a device that harnesses physical phenomenon unique to quantum mechanics (especially quantum interference) to realize a fundamentally new mode of information processing.In a quantum computer, the fundamental unit of information (called a quantum bit or qubit), is not binary but rather more quaternary in nature. This qubit property arises as a direct consequence of its adherence to the laws of quantum mechanics which differ radically from the laws of classical physics. A qubit can exist not only in a state corresponding to the logical state 0 or 1 as in a classical bit, but also in states corresponding to a blend or superposition of these classical states. In other words, a qubit can exist as a zero, a one, or simultaneously as both 0 and 1, with a numerical coefficient representing the probability for each state. This may seem counterintuitive because everyday phenomenon are governed by classical physics, not quantum mechanics -- which takes over at the atomic level. This rather difficult concept is perhaps best explained through an experiment. Consider figure a below:
 (Figure taken from a paper by Deutsch and Ekert) | Here a light source emits a photon along a path towards a half-silvered mirror. This mirror splits the light, reflecting half vertically toward detector A and transmiting half toward detector B. A photon, however, is a single quantized packet of light and cannot be split, so it is detected with equal probability at either A or B. Intuition would say that the photon randomly leaves the mirror in either the vertical or horizontal direction. However, quantum mechanics predicts that the photon actually travels both paths simultaneously! This is more clearly demonstrated in figure b. |
In an experiment like that in figure a, where a photon is fired at a half-silvered mirror, it can be shown that the photon does not actually split by verifying that if one detector registers a signal, then no other detector does. With this piece of information, one might think that any given photon travels either vertically or horizontally, randomly choosing between the two paths. However, quantum mechanics predicts that the photon actually travels both paths simultaneously, collapsing down to one path only upon measurement. This effect, known as single-particle interference, can be better illustrated in a slightly more elaborate experiment, outlined in figure b below:
 (Figure taken from a paper by Deutsch and Ekert) | In this experiment, the photon first encounters a half-silvered mirror, then a fully silvered mirror, and finally another half-silvered mirror before reaching a detector, where each half-silvered mirror introduces the probability of the photon traveling down one path or the other. Once a photon strikes the mirror along either of the two paths after the first beam splitter, the arrangement is identical to that in figure a, and so one might hypothesize that the photon will reach either detector A or detector B with equal probability. However, experiment shows that in reality this arrangement causes detector A to register 100% of the time, and never at detector B! How can this be? |
Figure b depicts an interesting experiment that demonstrates the phenomenon of single-particle interference. In this case, experiment shows that the photon always reaches detector A, never detector B! If a single photon travels vertically and strikes the mirror, then, by comparison to the experiment in figure a, there should be an equal probability that the photon will strike either detector A or detector B. The same goes for a photon traveling down the horizontal path. However, the actual result is drastically different. The only conceivable conclusion is therefore that the photon somehow traveled both paths simultaneously, creating an interference at the point of intersection that destroyed the possibility of the signal reaching B. This is known as quantum interference and results from the superposition of the possible photon states, or potential paths. So although only a single photon is emitted, it appears as though an identical photon exists and travels the 'path not taken,' only detectable by the interference it causes with the original photon when their paths come together again. If, for example, either of the paths are blocked with an absorbing screen, then detector B begins registering hits again just as in the first experiment! This unique characteristic, among others, makes the current research in quantum computing not merely a continuation of today's idea of a computer, but rather an entirely new branch of thought. And it is because quantum computers harness these special characteristics that gives them the potential to be incredibly powerful computational devices.
posted by rattlerbeast at
1:09 PM
0 Comments
